You are using an outdated browser version not supported by this website.
Click here to upgrade your browser

StructureStructure
EnclosureEnclosure
InteriorInterior
FinishFinish
ServicesServices
ExternalExternal
Privacy and Data Policy Terms of Use
© Quad Concepts Ltd.
Mapefloor PU 400 LV
Mapei Products in New Zealand
All products
4 4 6791 mapefloor pu400 lv a b 20kg int 934d756d5ca84cd492247620a5e2a69e c8e36550619843fbab2f3ffbd6e69281
Description

A two-component, self-levelling, neutral-coloured, highly flexible polyurethane binder with fillers, certified with an Environmental Product Declaration and VOC content tested.

Key Features
  • Pigmented, low-viscosity, high solid content polyurethane resin-based formulate
  • Very good elasticity
  • Strong crack-bridging property even at low temperatures down to -20°C
  • Good resistance to mechanical stresses
  • Low VOC emission (CDHP standard)
  • It can contribute to LEED credits
  • EPD (Environmental Product Declaration) compliant
  • Complies with the principles defined in EN 1504-9 (“Products and systems for the protection and repair of concrete structures - Definitions, requirements, quality control and evaluation of conformity - General principles for the use of products and systems”)and the minimum requirements of EN 1504-2, coating (C) according to the PI, MC, PR and IR principles (“Surface protection systems for concrete”).
Categories
Protective Coatings
Ranges
Industrial & Decorative Floors
Scope of Use
  • Mapefloor PU 400 LV is used to create elastic waterproof resin systems for concrete floorings of parking lots in the following situations:
  • As a highly elastic waterproof membrane for the Mapefloor Parking System HE, compliant the requirements of the class OS 11a (EN 1504-2)
  • As an elastic waterproof wearing layer for the Mapefloor Parking System ME, compliant the requirements of the class OS 11b (EN 1504-2)
  • For further information regarding the characteristics of each system, please refer to the relevant data sheets
Limitations on Use
  • Do not apply Mapefloor PU 400 LV on cementitious substrates with a moisture content higher than 4% or with capillary rising damp (contact MAPEI Technical Services).
  • Do not dilute Mapefloor PU 400 LV with solvent or water.
  • Do not apply Mapefloor PU 400 LV on dusty or crumbling substrates.
  • Do not apply Mapefloor PU 400 LV on substrates with oil or grease stains or with stains in general.
  • Do not apply Mapefloor PU 400 LV on substrates that have not been treated with Primer SN, or with another specific primer, or that have not been prepared as specified.
  • Do not mix partial quantities of the components to avoid mixing errors; the product may not harden correctly.
  • Do not expose the mixed product to sources of heat.
  • Protect the product from water for at least 24 hours after application.
  • If areas where the product is being applied need to be warmed up, use electric heaters only (heaters that run
  • on fossil fuels give off carbon dioxide and water vapour that could affect the finish of the coating).
  • The temperature of the substrate during the application and the hardening must be at least 3°C higher than the dew-point temperature. The air relative humidity must be max. 80%.
Other Performance Attributes
  • Low VOC emission (CDHP standard)
  • It can contribute to LEED credits
  • EPD (Environmental Product Declaration) compliant
  • Complies with the principles defined in EN 1504-9 (“Products and systems for the protection and repair of concrete structures - Definitions, requirements, quality control and evaluation of conformity - General principles for the use of products and systems”)and the minimum requirements of EN 1504-2, coating (C) according to the PI, MC, PR and IR principles (“Surface protection systems for concrete”).
Documents
Mapefloor PU 400 LV (all documents)
URL

Mapei have over 80 years of experience, with innovative quality adhesives, sealants and chemical products and systems for the building industry.

Product Enquiries

News from Mapei Products in New Zealand

A Second Line of Defence: Protecting Interior Substrates from Water Ingress
A Second Line of Defence: Protecting Interior Substrates from Water Ingress
Mapei Products in New Zealand
September 2026 Product News
Preserving History with NZ's First 6 Green Star Heritage Redevelopment
Preserving History with NZ's First 6 Green Star Heritage Redevelopment
Mapei Products in New Zealand
August 2026 Case Studies
When Façade Coatings Need to Do More Than Just Add Colour
When Façade Coatings Need to Do More Than Just Add Colour
Mapei Products in New Zealand
June 2026 Product News
View all news

Popular Products from Mapei Products in New Zealand

Mapelastic AquaDefense
Mapelastic AquaDefense
Mapei Products in New Zealand
Mapefer 1K
Mapefer 1K
Mapei Products in New Zealand
Mapelastic Guard
Mapelastic Guard
Mapei Products in New Zealand

View all products

Get a free weekly digest of essential news

New and updated architectural products, design solutions, inspiration, technical advice and more when you sign up for EBOSS.