• Recommended for commercial applications such as offices, workplaces, restaurants, canteens, cafes, and site sheds.
• Available in nominal storage capacities ranging from 3.0 to 40.0 litres, delivering between 18 and 240 cups at one time, with recovery rates up to 350 cups per hour depending on configuration.
• Wall-mounted over sink or drain
  

   

• Must be connected to a potable cold water supply with a minimum working pressure of 150 kPa for Autoboil and Hydroboil models, and 90 kPa for Econoboil models, up to a maximum pressure of 700 kPa.
• Models under 75-litre capacity can be plugged directly into a standard 220–240V 10-amp general power outlet (GPO).
• Capacities 75 litres and over must be hardwired.
• Designed exclusively for wall-mounted installation and must be positioned over a sink draining board or a properly drained plumbing fixture.
• A vent tundish must be installed to terminate to a safe, visible location in accordance with plumbing standards
• Not intended for outdoor installation; must be protected from environmental elements
• Cannot be connected to an unpotable water supply
• Must be installed by qualified tradespersons in accordance with manufacturer requirements
• specific structural wall-lining or framing reinforcement requirements needed ??

Zenith On-Wall Boiling Water Solutions, if designed, used, installed, and maintained in accordance with the conditions of Zenith Water's technical documents, will comply with, or contribute to compliance with, the following performance provisions of the NZ Building Code:

• B2 Durability — B2.3.1(c)
• F2 Hazardous Building Materials — F2.3.1
• G12 Water Supplies — G12.3.1, G12.3.2, G12.3.5
• Clause H1 Energy Efficiency — H1.3.4

Zenith Water (as a subsidiary of Zip Water) has pioneered on-wall instant boiling water systems since inventing the category in 1975. Zenith products have been widely specified and installed across commercial, institutional, and hospitality sectors throughout New Zealand and globally across more than 70 countries.

• Water Safety Certification: WMKA00099 Certification.  
• Filtration Compliance: Certified to NSF 42 (Aesthetic Effects) and NSF 53 (Health Effects)
• PowerPulse microprocessor controls keeping temperatures within a 0.2°C variation, high-performance insulation wrapping the inner boiling tank, and programmable sleep/timer modes to restrict power usage during vacancy hours.

Warranty

• Hydroboil models are covered by a limited 24-month comprehensive parts and labour warranty.
• Autoboil models are covered by a limited 12-month comprehensive parts and labour warranty.
• Aftercare Support: Supported across New Zealand by direct factory-trained service technicians and over 50 service agents covering the North and South Islands.