As waterproofing membrane for roofs and decks within the following scope:

Site conditions:

• All exposure zones excluding microclimates (para 4.2, NZS3604:2011), and
• Up to 6.0kPa ULS pressure differential.

Buildings that meet the following:

• For new buildings that comply with the structural requirements of the New Zealand Building Code, taking into account all applied loads specific to the building.
• In existing buildings where the designer and installer have assured themselves that the existing building is suitable for intended building work
• Where the substrate is as follows: plywood, concrete, ARDEX Polyiso board, or strandsarking
• Green roofs or roofs where loose laid ballast has been applied
• Decks and roofs may be of any slope or size provided that the designer has assured themselves that the structure and substrate have been designed to allow for all applied loads and that water will shed to avoid the risk of ponding

The ARDEX Polyiso is suitable for:

• Adhered, ballasted and mechanically fastened single-ply roofing systems
• Residential or commercial

• Must be installed to the ARDEX technical literature
• Must be installed by an ARDEX approved installer
• Test welds must be completed at start of work

If specified, installed and maintained in accordance with the conditions of this Product Technical Statement, the ARDEX WPM 715 WeldTec Membrane System will comply with or contribute to compliance with:

• B1 Structure: B1.3.1, B1.3.2, taking into account B1.3.3 (a, b, c, e, f, j, q)
• B2 Durability: B2.3.1(b), B2.3.2(a)
• E2 External Moisture: E2.3.1, E2.3.2
• F2 Hazardous Building Materials: F2.3.1
• G12 Potable Water: G12.3.2(c)

BRANZ:

• Test Report DC 3004-9 WPM 715 B
• Test Report DC 3004-11 WPM 715 G

All tests applicable to AS 4654.1 including:

• ASTM D6207 Dimensional stability
• AS/NZS 4858 Heat Ageing 
• CSIRO Moving joint test-Cyclic Movement
• AS 4654.1 Table A4 Temperature resistance, tensile strength and durability