The specially developed plaster mix contains a blended mix of aggregates, cement, proprietary ingredients and a unique fibre reinforcement which allows for easy application as a thin levelling coat for concrete block, brick walls and masonry surfaces. The fibre reinforcement MLC contains not only relieves curing stresses but also provides an excellent surface key for a variety of conventional plaster finishes.

• DO NOT apply plaster when the ambient or surface temperature is below 4°C or above 30°C or will be in that range for the 24-hour period after application. When hot, dry, or windy conditions exist, moist curing and protection must be provided. Material that is allowed to freeze or material that dries too quickly may suffer irreparable damage.
• DO NOT add any other materials to the plaster or deviate from the mixing or application procedures outlined in any of Specialized Construction Products’ technical data sheets without written approval from Specialized Construction Products.
• DO NOT apply plaster unless the substrate has been properly cleaned and prepared. See Surface Preparation above.
• DO NOT add any more water than prescribed by the technical data sheet for this product.
• DO NOT wet the wall prior to the application of this material.
• DO NOT reactivate the MLC plaster with more water once it has begun to set.
• DO NOT mix more plaster than you can use in 45 minutes.

• Specialized’s Brick & Masonry Levelling is guaranteed for 15 years from the date of practical completion.