Base mesh coat for use over concrete and masonry surfaces. Can also be used as part of a repair system for existing plaster builds. PowaFlex must be top coated with an acrylic texture before the application of minimum two coats of 100% acrylic paint or an approved latex exterior paint system in accordance with Specialized Construction Products paint specifications. 

Ensure all surface preparation instruction are followed.

All freshly applied material must be weather protected for a minimum of 24 hours after application. Exposure of applied product to rain, snow, dew, or other inclement weather conditions, direct hard sunlight or sources of heat while it is curing may have a detrimental effect on the finish. 

• DO NOT over­water, over mix, or remix aged PowaFlex with additional water.
• DO NOT mix more PowaFlex than you can use in 45 minutes.
• DO NOT use PowaFlex that has been mixed for more than one hour.
• DO NOT apply PowaFlex to wooden surfaces. 
• DO NOT apply PowaFlex over wet, frozen or frost affected surfaces. 
• DO NOT apply PowaFlex where it will be subjected to permanent immersion or where ponding will occur. 
• DO NOT reactivate PowaFlex with water once it has begun to set. 
• DO NOT wet the substrate prior to the application of PowaFlex. 
• DO NOT apply PowaFlex unless the substrate has been properly cleaned, primed and prepared