Rheem Commpak combines sophisticated electronics and pump technology to equalise hot and cold water pressures. A differential set point combined with the thermal mass in the system piping replicates storage. The result is mains pressure performance without the need for storage tanks which reduces the overall footprint and increased plant efficiency.
Commpak comes engineered and pre-assembled. This range is for Natural Gas only and is suitable for use in dead leg and recirculation systems utilising up to six Continuous Flow units.
The Rheem Commpak is a bank of two, three, four, five or six continuous flow water heaters (CFWH), factory manifolded in parallel complete with multi-speed pump/s, temperature sensors and a controller. Rheem Commpak offers the latest technology and is pre-engineered for small to medium sized projects.
Mains pressure performance
High efficiency continuous flow
Pre-engineered and assembled for ease of installation
Suitable for use in dead leg and recirculation systems
BMS/BAS controller interface
Indoor and outdoor models available
Available in the following model configurations:
Commpak CPI02 | Indoor Installation | 2 CFWH Units
Commpak CPE02 | Outdoor Installation | 2 CFWH Units
Commpak CPI03 | Indoor Installation | 3 CFWH Units
Commpak CPE03 | Outdoor Installation | 3 CFWH Units
Commpak CPI04 | Indoor Installation | 4 CFWH Units
Commpak CPE04 | Outdoor Installation | 4 CFWH Units
Commpak CPI05 | Indoor Installation | 5 CFWH Units
Commpak CPE05 | Outdoor Installation | 5 CFWH Units
Commpak CPI06 | Indoor Installation | 6 CFWH Units
Commpak CPE06 | Outdoor Installation | 6 CFWH Units