• Matador® Mini Post Balustrade is for Domestic and Residential Occupancy types A, A Other and C3 Residential only Occupancy Types as per AS/NZ 1170.1.2002
• Suitable for both balustrading and pool fencing
• Up to Very High Wind Zone

• Not suitable for C1/C2, C3, C5 or D Commercial Occupancy Type
• Edgetec Matador® Mini Post balustrade must only be installed in accordance with the Edgetec Matador Mini Post product manual Issue 10-21 v1
• Glass must have a minimum strength of 100mpa
• All glass edges must be polished
• Up to Very High Wind Zone 

• Designed and manufactured in New Zealand, the Edgetec Matador Mini Post balustrade system has been engineered and tested by independent engineers to comply with NZ standards NZS4223.3.2016, AS/NZS1170, New Zealand Building Code B1, B2 and F4, NZBC Clause F9 & 162C of the Building Act (pool safety legislation), NZS8500:2016.
• Edgetec Matador Mini Post balustrade is suitable for Occupancy A, A other and C3 Residential
• An interlinking top rail has been incorporated into the Edgetec range to comply with new 2016 balustrade regulations — NZS4223.3.2016
• Any deviation from standard fabrication or installation must be accompanied by a site specific PS1, with site specific calculations and drawings

Juralco has over 18 years experience designing and installing balustrades throughout New Zealand and continues to focus on supporting and developing its dealer network.

The Edgetec Matador® Mini Post Balustrade range was introduced in 2021.

• All infill glass must be toughened safety glass, complying with AS/NZS 2208
• Dulux Duralloy powder coating is used for properties greater than 100m from high tide level, where AMA 2603 performance is required
• Dulux Duratec powder coating must be used for properties greater than 10m and up to 100m from high tide level where AMA 2604 performance is required