Powerglide provide service and passenger elevator solutions for commercial buildings of up to 4 full floors. Accessibility options are also available.
Powerglide's Teleglide cylinder design means the lift runs on its own rails and doesn’t touch the sides. This makes Powerglide Elevators fast, stable and safe, while being low maintenance, and offering flexibilty of design. There's no need for deep holes, or roofline modifications, so a Powerglide Elevator is suitable for retrofittng, and the car interior can be customised to suit individual layouts and decors.
Fast and Smooth:
High speed — 300mm per second
Approximately 10 seconds to travel up or down 1 floor
Guide rail system eliminates sideways movement for greater stability
5 year 'no maintenance' guarantee
No seals to change, no cylinders, pulleys, or ropes
Built in safety controls doors and lights
Ability to exit the lift in the event of a powercut
Minimum internal shaft size required of 1190mm deep x 800mm wide (across rails)
Requires ceiling height at top level of at least 2100mm
Requires pit depth of at least 300mm, travel of <3600mm requires cylinder caisson inserted into ground
Statement of Building Code Compliance
The Powerglide is manufactured and installed to comply with the requirements of NZBC D2/AS1 as an acceptable solution using NZS 4334:2012, and also as an alternative solution using the standards of AS 1735.18 2002 in conjunction with NZBC D2/AS1.
Other Performance Attributes
5 year maintenance free* guarantee
*Unlike a residential / domestic installation, a commercial disabled access elevator must be inspected regularly — at least once every 12 months
If, during a maintenance check, a fault is found with the elevator, then the conditions of the above 5 year maintenance free guarantee will apply