Resene Multishield+ by Resene

Resene Multishield+

Description

Resene Multishield+ is a tough waterborne glaze for use on masonry and brick surfaces as a protective finish and glaze. Enhances the colour and natural beauty of masonry, brick and stone. Increases the durability of high build acrylic specialist coatings. Provides an exceptionally tough, scrubbable film for the protection of wallpaper.

Key Features

Colour: Clear
Excellent intercoat and substrate adhesion
Non-yellowing
Excellent protection of brick, stone and fibre cement
Resistant to chipping and peeling
Resistant to oil and fat splashes
Resistant to alkaline cleansers
An Environmental Choice approved product

Scope of Use

Brickwork / artificial brickwork
Fibre cement
High build acrylics
Masonry surfaces
Slate
Stonework / artificial stonework
Wallpaper

Limitations on Use

Do not apply at temperatures below 10°C or when it is liable to drop below 10°C during the drying period.
Where waterproofing problems are encountered, a pigmented high build system, such as Resene X-200 (see Data Sheet D62) should be used.
When sanding is required use fine wet and dry sandpaper with water.
Not recommended for exterior tile or decorative aggregate flooring where water ponding may occur.
Not recommended for use as a varnish on exterior timber or large areas of interior timber.
Will not penetrate or reinforce weak surfaces.
Not recommended directly over pre-primed and factory sealed substrates. Consult with a Resene representative for an effective system.
Many factory primers do not have good U.V. stability and will breakdown underneath clear coatings. Over a U.V. sensitive primer a pigmented topcoat is required to ensure long term durability.