• Suitable for use in residential, commercial and industrial situations

• To comply with security standards, all hinged and sliding doors must be fitted with triple point locking

Forced Entry Testing to AS5039:

• Dynamic Impact Test: Simulating a physical attack on the screen mesh to attempt to force the mesh out of the frame and gain entry
• Lock Attack: Consisting of a jemmy test on all locking points with a lever to attempt to break into or release the locking mechanism and gain entry
• Hinge Attack: Consisting of a jemmy test on all hinge points with a lever to attempt to break into or release the hinge and gain entry
• Knife Shear Test: Simulating an attack on the mesh with a very sharp knife to attempt to cut the mesh and gain entry

Simulated Wind Driven Debris Impact Test:

• Impact Test: A 4 kg piece of hardwood impacting the screen at a velocity of 29m/s (104.4km/h) followed by 8mm steel balls impacting the screen at the same velocity of 29m/s

Ulltrasafe framing is extruded from 6063 T6 premium grade aluminium alloy. The woven wire mesh is manufactured from 316 grade stainless steel to ensure corrosion resistance and strength. The system is tested and backed by an extensive warranty.

Ulltrasafe’s unique design allows assembly without the need for screws, rivets or pins penetrating the stainless steel mesh eliminating any possible cause for corrosion.

Maintenance

Regular cleaning (at least 6 monthly) of the powder coating with water and a mild detergent is required to remove grime, dirt and organic growth, to maximize the life and appearance of the surface finish.

When cleaning powder coated surfaces, proceed as follows:

• Carefully remove any loose deposits with a wet sponge
• Use a soft, non-abrasive brush and a mild detergent solution to remove dirt, salt and other deposits
• Rinse off with clean water